K4 Sanitiser

Before sanitising ensure all surface are cleaned with suitable detergent. Dilute with cold potable water into a clean applicator bottle.

No-rinse application:
This product may be used as a no-rinse sanitiser on clean hard surfaces. Before use, all edible product and packaging material must be removed from the room or carefully protected. After use, a rinse with potable water is not required but food contact surfaces must be thoroughly drained / dried to minimise residues. For hard surfaces and equipment to ensure 200ppm use at the ratio of 1:399 (0.25% solution, 2ml per 750ml). Apply by spray or clean cloth, Allow contact time of minimum 10 minutes.

Rinse applications:
Use at the ratio of 1:199 (0.5% solution, 4ml per 750ml, 400ppm). Apply in a manner that avoids food contamination. Allow contact time of 10 minutes minimum then rinse with clean, potable water.

Foot bath:
Dilute at the ratio of 1:99 (1% solution, 8ml per 750ml, 800ppm). It is recommended to do test strip verification of diluted solutions to ensure desired concentration.

Under Good Practise Protocol, based on accepted international research, a 0.5% solution of this product, diluted with potable water, is recommended with liberal application on clean hard surfaces, with a minimum contact time of 10 minutes. At this concentration the product provides 400ppm.