Heavy duty, phosphoric acid- based, low foaming, cleaner / sanitiser. Formulated specifically for CIP applications to remove undissolved solids and alkaline residues. It also removes surface rust from ferrous metals and protects against subsequent re-rusting.
Dilution rates for CIP applications vary depending on soiling levels.
For most general daily operations use at a ratio of 1:1000 to 1:100 (0.1-1% soln, 1-10ml per litre) with potable water. Circulate for 15-20 minutes.
Ensure all surfaces are thoroughly rinsed. Stronger dilution rates may be used under representative or plant SOP instruction.
Under Good Practise Protocol diluted solution of this product as stated provides general biostatis using internationally recognised antibacterial agents with a recommended minimum contact time of 10 minutes. At 1% concentration this product provides 100PPM QAC.
This product not quite right? We've picked out a few more that may suit your application. Alternatively contact your Kemsol representative or email Kemsol for more information.
MPI APPROVED C31
(All animal product except dairy)
Before use, all edible product and packaging material must be removed from the room. After using this compound, food surfaces must be thoroughly rinsed with potable water before production starts.
| 200Lt | FK-PHORIC200 |
| 20Lt | FK-PHORIC20 |
| 5Lt | FK-PHORIC05 |
| Spray Applicator | BK-PHORIC1 |
We are committed to continual improvement in our environmental performance, and have established a number of goals and initiatives helping achieve this objective.
Where possible we always use biodegradable raw materials and all our finished product packaging is reusable or recyclable.
This is only a start, we continually strive to better our environmental performance. Visit chemicalsolutions.co.nz for more information.
©2024 Kemsol. Site by Zulu Shopfront
A handy guide containing all our Kemsol products with MPI approval
Click to get your copy
Log in to Media Hub 
